Polypropylene Engineering Micro Fiber for Concrete/Mortar.

Applications ;PP Fiber is ideally designed for use in the following applications:  Slab on grade, Stamped concrete ,Pre-cast concrete, Water tanks, Pavements,Shotcrete,Renders and plastering, Composite decks etc. About this item Solved Crack Trouble: Mixing Polypropylene fiber and mortar to make the mortar stronger, increase the vibration resistance of the cement, so to reduce the cracking problem, which can suitable for strengthening cement projects Material: Polypropylene Fiber is different from ordinary fiberglass fiber, polypropylene fiber has the same length and standard, smooth overall, ordinary fiber is rough and varying standards. Widely Application: Anti seepage polypropylene fiber for cement for concrete reinforcement are good at increasing cement density, so they can reduce infiltration to some extent, can be widely applied to countertop, fireplace surrounds, basement, pond, exterior wall and other wet places. Easy to Use: you will get 1 packs of polypropylene fiber , just blend sand, cement and fibers for concrete, then add the right amount of water, and stir evenly, Add more for high impact or severe freeze or thaw areas. Friendly Customer Service: If you have any issue during using Polypropylene Fiber, pls contact us at any time, we will reply you in first time while we have received your message. Recommended Dosage Compatibility Dispensing This product is an article as defined in article 3 of regulation (EC) No 1907/2006 (REACH). It contains no sub- stances which are intended to be released from the article under normal or reasonably foreseeable conditions of use. For safe use follow the instructions given in this product data, APPLICATION These are Polypropylene (PP) fiber of 6 mm length. These micro fibers prevent crack formation and provide reinforcement. They are mainly used in plasters for finishing coat or ornamental castings for crack prevention as well as additional reinforcement. Suitable care has been taken to insure dispersion of fibers for hand mixing of mortar. It conform to ASTM C1116/ C1116M-06 4.1.3 Type III & BS EN 14889-2: 2006. Minimum Dosage:- For mortar- 600gm/m3 and for concrete- 900gm/m3 or 200g/50kg cement. Results improve with higher dosage of fiber. Kindly optimize the dosage depending on the requirement. DIRECTION OF USE For Machine mixing:- Small quantity of water is dosed in empty drum to clean the drum after each batch. Add fibers in the rotating drum. Then add chips/sand/cement/water in the concrete mixer and continue normal operation. For Manual Mixing:- The fiber is dosed in a bucket half filled with water. The water in stirred vigorously, which disperses the fiber. The water and fiber mixture is spread over the other cementitious mix. For dosing in Ready Mix Truck:- Add fibers in small lots in the rotating drum. After dosing is complete allow extra 20-30 revolutions of drum at maximum RPM. color : White